For Sale

LIMB BY LIMB · Post by **LIMB BY LIMB** » Mon Jan 09, 2012 9:23 pm

I have a pre fender SWR Engineering 6x10 4 ohm cab for sale. Works great. Just can't use it with my set up right now. asking $400

onegunguitar · Post by **onegunguitar** » Mon Jan 09, 2012 9:28 pm

This is a great sounding cab..I used to own it so I know

LIMB BY LIMB · Post by **LIMB BY LIMB** » Mon Jan 09, 2012 11:17 pm

Yeah and if I could find a way to make it 8 ohms I would keep it

witchhunt · Post by **witchhunt** » Mon Jan 09, 2012 11:41 pm

You can achieve a 10 ohm resistance if the speakers are 16 ohm.
http://www.soundcitysite.com/sc_webpage ... wiring.pdf

LIMB BY LIMB · Post by **LIMB BY LIMB** » Tue Jan 10, 2012 12:18 am

witchhunt wrote:You can achieve a 10 ohm resistance if the speakers are 16 ohm.
http://www.soundcitysite.com/sc_webpage ... wiring.pdf

That wouldn't hurt anything running out of a 8 ohm head correct? If the impedance is greater than the ra.ting on the head. I want to run this cab 8ohm bridged mono out of my David Eden world tour 600

lonewolf · Post by **lonewolf** » Tue Jan 10, 2012 1:20 am

Running a 10 ohm cabinet off an 8 ohm output is not a problem.

Those are only theoretical numbers anyway. Impedance varies wildly with the frequency of the signal. Getting to with 25% of rated impedance should be OK.

LIMB BY LIMB · Post by **LIMB BY LIMB** » Tue Jan 10, 2012 1:30 am

Thanks folks!! Then this cab is no longer for sale . Wish I would of known this about 6 months ago.

onegunguitar · Post by **onegunguitar** » Tue Jan 10, 2012 1:58 am

Yea Matt,if you ever have any electronic questions...just ask lonewolf,he'll help you out.

jblasko317 · Post by **jblasko317** » Tue Jan 10, 2012 3:36 am

as long as the impedance of the speaker is greater than the output impedance of the amp, you are fine. If the speaker is less than, it can cause much damage to the amp.....blown output transformer, blown caps, grid resistors, and the likes